Configuring Pim-Sm Register Messages - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
The switch can work normally under the control of default values. The S3700 allows the users
to adjust the parameters as required.
Pre-configuration Tasks
Before adjusting control parameters for source registering, complete the following tasks:
l
l
Data Preparation
To adjust control parameters for source registering, you need the following data.
No.
1
2
3
4

7.8.2 Configuring PIM-SM Register Messages

You can configure filtering policies for Register messages on all the devices that may become
RPs. By default, the checksum is calculated based on the entire Register message. You can
configure the device to calculate the checksum based on only the header of a Register message.
Context
Do as follows on all switchs that may become an RP:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim
The PIM view is displayed.
Step 3 Run:
register-policy advanced-acl-number
The policy for filtering Register messages is set.
Issue 01 (2011-10-26)
NOTE
It is recommended to adopt default values if there is no special requirement.
Configuring a unicast routing protocol
Configuring Basic PIM-SM Functions
Data
ACL rules used by the RP to filter Register messages
Whether the checksum is calculated only according to the header of a Register
message
Timeout for keeping the suppressed state of registering
Interval for sending null Register messages to the RP
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 PIM-SM (IPv4) Configuration
163