Enabling A Bsr Administrative Domain; Configuring The Boundary Of A Bsr Administrative Domain - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
Data Preparation
To configure a BSR administrative domain, you need the following data.
No.
1
2

7.6.2 Enabling a BSR Administrative Domain

Enable BSR administrative domains on all devices in a PIM-SM network.
Context
Do as follows on all switchs in the PIM-SM network:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim
The PIM view is displayed.
Step 3 Run:
c-bsr admin-scope
The division of BSR administrative domains is enabled in a PIM-SM network.
----End

7.6.3 Configuring the Boundary of a BSR Administrative Domain

After an interface is configured as a BSR administrative domain boundary, all the multicast
packets for the groups in this BSR administrative domain cannot pass this interface.
Context
Do as follows on all switchs at the boundary of a BSR administrative domain:
Procedure
Step 1 Run:
system-view
Issue 01 (2011-10-26)
Data
Priority and hash mask length for electing a BSR in a BSR domain
Priority and hash mask length of electing the global domain BSR
NOTE
The switchs outside the BSR administrative domain cannot forward the multicast packets of the BSR
administrative domain.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 PIM-SM (IPv4) Configuration
154