Enabling Ip Multicast - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
IGMP needs to be enabled on the VLANIF interface that is connected to the host. The matching
IGMP version needs to be configured on the S3700 and host because the IGMP messages vary
according to version. The later version on the S3700 side is compatible with the earlier version
on the host side. Other configurations can be performed only after IGMP is enabled.
The host where the IGMP is run responds to the IGMP Query message of the S3700. If the host
gives no response and the operation times out, the S3700 considers that the multicast group does
not contain any member on the network segment and cancels data forwarding.
To enable hosts on the network segment of the interface to join the specified groups and receive
packets from the groups, you can set an ACL on the related interface to limit the range of groups
that the interface serves.
Pre-configuration Tasks
Before configuring basic IGMP functions, complete the following tasks:
l
l
Data Preparation
To configure basic IGMP functions, you need the following data.
No.
1
2
3
4

5.3.2 Enabling IP Multicast

Context
The IP multicast function is the prerequisite of configuring other multicast protocols. Do as
follows on the S3700 connected to a host.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Issue 01 (2011-10-26)
Configuring the parameters of the link layer protocol and the IP address of the interface to
enable the link-layer protocol
Configuring the unicast routing protocol to ensure that IP routes between nodes are
reachable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Data
ID of the VLAN to which the interface
communicating with the host belongs
IGMP version
IP addresses of the multicast group and
multicast source
ACL rule for filtering multicast groups
5 IGMP Configuration
71