Networking Requirements - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast

Networking Requirements

On the multicast network shown in
the VOD information from the multicast source. Switch A is the DR on the source side. Switch
B and Switch C are connected to the segment where hosts reside. When the DR changes, other
switches on the network segment can detect the change of the DR quickly.
Figure 7-3 Configuring the PIM BFD networking in the shared network segment
Source
10.1.7.1/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
Data Preparation
To complete the configuration, you need the following data:
l
Procedure
Step 1 Configure the IP address of each interface and the unicast routing protocol.
# Configure IP addresses and masks of interfaces on the switches according to
Configure OSPF between switches to ensure that the switches can communicate at the network
layer and update routes through the unicast routing protocol.
For details on how to configure IP addresses of interfaces, see IP Addresses Configuration in
the Quidway S3700 Series Ethernet Switches Configuration Guide - IP Service. For details on
Issue 01 (2011-10-26)
SwitchA
Eth0/0/1
SwitchB
Eth0/0/2
User1
Configure PIM BFD on the interfaces that connect switches to the network segment where
the host is located.
Parameters of PIM BFD sessions
NOTE
This configuration example describes only the commands used to configure PIM-SM BFD.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 7-3, PIM-SM is run between switches. Hosts receive
Eth0/0/1
PIM-SM
Eth0/0/2
VLAN100
User2
7 PIM-SM (IPv4) Configuration
SwitchC
Figure 7-3.
187