Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
multicast routing-enable
IP multicast routing is enabled in the public network instance.
----End
7.3.3 Enabling Basic PIM-SM Functions
An interface can set up PIM neighbor relationship with other devices after PIM-SM is enabled
on it.
Context
Do as follows on the switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a VLANIF interface, or an Loopback interface.
Step 3 Run:
pim sm
PIM SM is enabled.
After PIM SM is enabled on the interface and PIM neighbor relationships are set up between
switches, the packets from the PIM neighbors can be processed.
----End
7.3.4 (Optional) Configuring a Static RP
When only one RP exists in the network, you can manually configure a static RP rather than a
dynamic RP. This can save the bandwidth occupied by message exchange between the C-RP
and the BSR. The configurations about the static RP should be the same on all the devices in a
PIM-SM domain.
Issue 01 (2011-10-26)
NOTE
When the switch is distributed in the PIM-SM domain, enable PIM-SM on all non-boundary interfaces.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 PIM-SM (IPv4) Configuration
141