Removing The Hard Disk Drive; Figure 9-1 Drive Locations - Sun Microsystems SPARCstation 4 110 Service Manual

CD-ROM
drive (top)
FIGURE 9-1
9.1.1

Removing the Hard Disk Drive

1. Shut down and power off the system.
See Section 6.1 "Powering Off the System" on page 6-1.
2. Remove the cover and attach a wrist strap.
See Chapter 7.
3. To release the disk drive handle, press the plastic latch located at the end of the
drive.
4. Lift the drive handle to its vertical position.
When lifted, the drive handle acts as a lever to disengage the drive from its bracket.
5. Disconnect the disk drive SCSI cable from the connector at the rear of the drive.
6. Grasp the drive bracket handle and lift the drive straight up and out of the
chassis.
See
FIGURE 9-2
9-2 SPARCstation 4 Model 110 Service Manual • July 1996
Drive Locations
. Place the drive on an antistatic surface.
Diskette drive
(bottom)
Hard drive