Removing A Cd-Rom Drive - Sun Microsystems Ultra 60 Upgrade Manual

Removing a CD-ROM Drive

1. Remove the screws securing the drive bracket to the chassis (
CD-ROM drive
FIGURE 2-9
2. Remove the DC harness from the clip located on the drive bracket.
3. Disconnect the DC harness from the peripheral power cable at P1.
4. Push the drive bracket toward the disk drive bay and gently flip it over. Place the
drive bracket on top of the disk drive bay.
5. Disconnect the SCSI cable from the CD-ROM drive.
6. Disconnect the peripheral power cable:
a. From the CD-ROM drive (P3).
b. From the diskette drive (P2) if any.
7. Disconnect the diskette cable from the diskette drive (if any).
8. Place the bracket on the antistatic mat.
14 Sun Ultra 2 Series to Sun Ultra 60 System Upgrade Guide • December 1997
Diskette drive (not visible)
Drive bracket and drives
FIGURE 2-9
Drive bracket
).