Table of Contents
Advertisement
4.11.1.6 IP Filter
The IP filter interface is shown as in Figure 4-93. You can add IPs in the following list. The list supports a
max of 64 IP addresses. The system supports valid IPv4 and IPv6 addresses. Please note the system
needs to check the validity of all IPv6 addresses and implement optimization.
After you enabled the trusted sites function, only the IPs listed below can access the NVR.
If you enable the blocked sites function, the following listed IP addresses cannot access the NVR.
Enable: Highlight the box here and you can check the trusted sites function and blocked sites
function. You cannot see these two modes if the Enable button is grey.
Type: You can select trusted site or blacklist from the dropdown list. You can view the IP address
on the following column.
Figure 4-91
Figure 4-92
89
Advertisement
Table of Contents
