Encode - Amcrest NVR11H Series User Manual

Day/Night

5.9.1.3 Encode

5.9.1.3.1 Encode
The encode interface is shown as below. See Figure 5-23.
Please refer to the following sheet for detailed information.
Parameter
Channel
Video enable
Code stream
type
sunny, cloudy, home, office, night, disable, etc to adjust the
video to the best quality.

Auto: The auto white balance is on. The system can auto
compensate the color temperature to make sure the
video color is accurate.

Sunny: The threshold of the white balance is in the sunny
mode.

Night: The threshold of the white balance is in the night
mode.

Customized: You can set the gain of the red/blue
channels. The value raneges from 0 to 100.
This is to set device color and the B/W mode switch. The
default setup is auto.

Color: Device outputs color video.

Auto: Device auto selects to output the color or the B/W
video according to the device feature (The general
brightness of the video or if there is IR light or not.)

B/W: The device outputs black and white video.

Sensor: This is to set when there is peripheral connected
IR light.
Figure 5-23
Function
Please select a channel from the dropdown list.
Check the box here to enable the extra stream video. This item
is enabled by default.
This includes main stream, motion stream, and alarm stream.
You can select different encode frame rates for different events.
The system supports active control frame function (ACF). It
allows you to record in different frame rates.
137