Preview Tour Parameters - Amcrest NVR11H Series User Manual

Now you can set corresponding information.

Resolution: There are four options: 1280×1024 (Default), 1280×720, 1920×1080, and 1024×768.
Please note the system needs to reboot to activate the current setup.

Transparency: Here is where you adjust the transparency of the menus. The value ranges from 0%
to 100%.

Time display: You can select whether or not to display the time when the system is in playback.

Channel display: You can select whether or not to display the channel name when system is in
playback.

Image enhance: Check this box to optimize the image of the preview video.

Original scale: Check this box to restore the video's original scale.
Click the Save button to save the current setup.

4.5.5 Preview Tour Parameters

Set preview display mode, channel display sequence, and tour setup.

Set preview display mode: On the preview interface, right mosue click and you can the view
right-click menu. Now you can select the preview window amount and channel.

Set channel display mode: On the preview interface, if you want to change the position of channel 1
and channel 8, please left click the channel 1 video window and then drag to the channel 8 video
window, release button, and channel 1 and channel 8 will change positions.

Tour setup: Here you can set the preview window channel display mode and interval. Please follow
the steps listed below.
From Main Menu->Setting->System->Display->Tour, you can see an interface shown as in Figure 4-25.
Here you can set tour parameters.

Enable tour: Check the box here to enable the tour function.
Figure 4-24
33