Alarm Out - Amcrest NVR11H Series User Manual

Please refer to the following sheet for detailed information.
Parameter
Enable tour
Interval
Split
Motion
tour/Alarm
tour

5.9.5.4 Alarm Out

The alarm output interface is shown as below. See Figure 5-92
Here you can set alarm output mode: auto/manual/stop.
Figure 5-91
Function
Check this box here to enable the tour function.
Here is where you adjust the interval in which to change cameras.
The value ranges from 5 to 120s. The default setup is 5s.
Here you can set the window mode and channel group. The system
can support 1/4/8/9/16/25/36-window according to the device
channel amount.
Here you can set the motion detect tour/alarm tour window mode.
The system supports 1/8-window.
178