Storage; Schedule - Amcrest NVR11H Series User Manual

Please refer to the following sheet for detailed information.
Parameter Function
Event
Type
Enable
Alarm Out
Latch
Show
message
Alarm
upload
Send
Email
Buzzer

5.9.4 Storage

5.9.4.1 Schedule

In this interfaces, you can add or remove the scheduled recording setup. See Figure 5-72.
There are four record modes: general (auto), motion detect, alarm, and MD&alarm. There are six periods
in one day.
You can view the current time period setup from the colored bars.

Green stands for the general record/snapshot.

Yellow stands for the motion detect record/snapshot.

Red stands for the alarm record/snapshot.

Blue stands for MD&alarm record/snapshot.
The abnormal events include: No disk, disk error, no disk space, network
disconnection, IP conflict, and MAC conflict.
You can set one or more items here.
Less than: You can set the minimum percentage value here (For no disk
space only). The device can alarm when capacity is not sufficient.
You need to check the box to enable this function.
Check the box here to enable the selected function.
You need to select the alarm output port so that the system can activate
the corresponding alarm device when an alarm occurs. You need to
check the box to enable this function.
The alarm output can delay for the specified time after an alarm stops.
The value ranges from 1s to 300s.
The system can pop up a message to alarm you on the local host screen
if you enabled this function.
The system can upload the alarm signal to the center (including the
alarm center).
If you enabled this function, the system can send out an email to alert
you when an alarm occurs.
Check the box here to enable this function. The buzzer beeps when an
alarm occurs.
Figure 5-71
166