Table of Contents
Advertisement
3 Device Installation
Note: All the installation and operations here should conform to your local electric safety rules.
3.1 Check Unpacked NVR
When you receive the DVR system in the packaging, unpack it, and check all sides of the NVR for any
physical damage. The protective materials used in the packaging of the NVR can protect most accidental
damage during transportation, but to ensure that your equipment is operating as expected, it is
recommended to inspect the product before proceeding further. On the NVR unit, check specifically that
the label on the bottom of the NVR is not damaged. The serial number of the unit is often needed to
provide support.
3.2 HDD Installation
Important: Please turn off the power before you install or replace the HDD.
This unit comes with a HDD already installed so this is only needed in order to replace a HDD.
You can refer to the Appendix for HDD space information and recommended HDD brand. Please use
HDD of 7200rpm or higher. Usually we do not recommend PC HDDs.
Please follow the instructions below to install the hard disk.
3.2.1 NVR11H/11H-P/41H-8P Series
1. Loosen the screws on the
rear panel and side panels.
4. Turn the device upside down
and tighten the screws in firmly
into in the chassis.
2. Attach four screws in the
HDD (Turn just three times).
5. Attach the HDD securely.
3. Place the HDD in accordance with
the four holes in the bottom.
6. Connect the HDD cable and
power cable.
13
Advertisement
Table of Contents
