Amcrest NVR11H Series User Manual page 80


Latch: When motion detection is complete, the system auto delays detecting for the specified
time. The value ranges from 1-300 seconds.

Show message: The system will show a pop up a message on the local host screen when an
alarm occurs.

Alarm upload: The system will upload the alarm signal to the network (including the alarm
center).

Send email: The system will send out an email to alert you when an alarm occurs.

Record channel: The system will automatically record on the channel(s) once motion is detected.
Please make sure you have set MD recording in the Schedule interface (Main
Menu->Setting->Schedule) and scheduled recording in the manual record interface (Main
Menu->Advanced->Manual Record)

PTZ activation: Here you can set PTZ movement when an alarm occurs, such as go to preset,
tour, or pattern. Click the Setup button to see an interface is shown as in Figure 4-70

Record Delay: The system can delay recording for a specified time after the alarm has ended.
The value ranges from 10s to 300s.

Tour: Here you can enable the tour function when an alarm occurs.

Snapshot: You can enable this function to take a snapshot when a motion detect alarm occurs.

Video matrix: Check the box here to enable this function. When an alarm occurs, the SPOT OUT
port displays the device's video output. It displays video (1-window tour) from the alarm
activation channel you select in the Record channel option.

Buzzer: Highlight the icon to enable this function. The buzzer beeps when an alarm occurs.
Please highlight check
click the save button and the system will go back to the previous menu.
Note:
In motion detection mode, you can not copy/paste to different channel setup since the video in each
channel may not be the same.
In Region Setup, you can left click and then drag it to set a region for motion detection. Click Fn to
switch between arm/disarm motion detection. After setting the zones, click the Enter button to exit.
to select the corresponding function. After all the settings are set, please
X
70