Table of Contents
Advertisement
Please refer to the following sheet for detailed information.
Parameter
Enable
Period
Anti-dither
Sensor type
Record channel
Record Delay
Alarm out
Latch
Show message
Figure 5-62
Function
You need to check this box to enable this function.
Please select a channel from the dropdown list.
This function enables the alarm during specified periods.
There are six periods in one day. Please check the box to
enable the corresponding period.
Select the day. If you do not select this, the current setup
applies to today only. You can select the all week column
to apply to the whole week.
Click the OK button to go back to local alarm interface.
Please click save button to exit.
System only recognizes one event during the anti-dither
period. The value ranges from 5s to 600s.
There are two options: NO/NC.
The system automatically records once an alarm is
triggered for the selected channel(s). Please note you
need to set the alarm record period. Go to Storage->
Schedule to set the current channel for schedule record.
The system can delay the recording for a specified time
after the alarm ends. The value ranges from 10s to 300s.
Enables the alarm activation function. You need to select
the alarm output port so that the system can activate the
corresponding alarm device when an alarm occurs.
The system can delay the alarm output for a specified time
after an alarm ends. The value ranges from 1s to 300s.
The system can pop up a message to notify you on the
162
Advertisement
Table of Contents
