Table of Contents
Advertisement
Parameter
Latch
Show
message
Buzzer
Alarm upload
Send Email
Tour
PTZ
Activation
Snapshot
Video Matrix
5.9.3.1.2 Video Loss
The video loss interface is shown as in Figure 5-58.
Please note the video loss does not support anti-dither, sensitivity, or region setup. For the rest of the
settings, please refer to chapter 5.9.3.1.1 motion detect for detailed information.
Function
device when an alarm occurs.
The system can delay the alarm output for a specified time after an
alarm has ended. The value ranges from 1s to 300s.
The system can pop up a message to alarm you on the local host
screen if you enabled this function.
Check the box here to enable this function. The buzzer beeps
when an alarm occurs.
The system can upload the alarm signal to the alarm center.
If you enabled this function, the system can send out an email to
alert you when an alarm occurs.
You need to click the Setup button to select a tour channel. The
system begins a 1-window or multiple-window tour display among
the channel(s) you set to record when an alarm occurs. See Figure
5-56.
Here you can set PTZ movement when an alarm occurs, such as
go to preset X. See Figure 5-55.
Click Setup to select a snapshot channel. See Figure 5-57.
This function is for motion detect only. Check the box here to
enable the video matrix function. Right now the system supports a
one-channel tour function. The system takes the "first come, first
served" principle to deal with the activated tour. The system will
process the new tour when a new alarm occurs after the previous
alarm ended. Otherwise it restores the previous output status
before the alarm was triggered.
159
Advertisement
Table of Contents
