Table of Contents
Advertisement
Please refer to the following sheet for detailed information.
Parameter
Enable
Period
Anti-dither
Sensitivity
Region
Record
channel
Record Delay
Alarm out
Figure 5-56
Figure 5-57
Function
You need to check this box to enable the motion detection
function. Please select a channel from the dropdown list.
The motion detection function becomes activate during the
specified periods. See Figure 5-53.
There are six periods in one day. Please draw a circle to enable
the corresponding period.
Click the OK button to go back to motion detection interface then
click the Save button to exit.
The system only sets off one event during the anti-dither period.
The value ranges from 5s to 600s.
There are six levels. The sixth level has the highest sensitivity.
Once you enable the motion detection type, you can click Setup to
set motion detection zone. The interface is shown as in Figure
5-54. Here you can set motion detection zone. There are four
zones for you to set. Left drag the mouse to select a zone. After
you completed the setup, please click the ENTER button to exit the
current setup. Please click the save button to save the current
setup. If you click the ESC button to exit the region setup interface,
the system will not save your zones.
The system auto activates motion detection channel(s) to record
once an alarm occurs. Please note you need to set the motion
detect record period. Go to Storage->Schedule to set the current
channel as schedule record.
The system can delay the recording for a specified time after the
alarm has ended. The value ranges from 10s to 300s.
Enable the alarm activation function. You need to select alarm the
output port so that system can activate the corresponding alarm
158
Advertisement
Table of Contents
