Table of Contents
Advertisement
Start address/end address: Select one type from the dropdown list and you can input an IP
address in the start address and end address. Now you can click Add IP address or Add IP
section to add it.
For the newly added IP address, it is in enable status by default. Remove the √ before the item
a)
to remove it from the list.
b)
The system supports a max of 64 items.
c)
The address column supports IPv4 or IPv6 format. If it is an IPv6 address, the system can
optimize it. For example, the system can optimize aa:0000: 00: 00aa: 00aa: 00aa: 00aa: 00aa as
aa:: aa: aa: aa: aa: aa: aa.
d)
The system automatically removes space if there is any space before or after the newly added
IP address.
e)
The system only checks the start address if you add a single IP address. If an IP section is
added, the system checks the start and end end address to make sure the end address is larger
than the start.
f)
The system may check if newly added IP address exists or not. The system does not add the
address if it does not exist.
Delete: Click this to remove a specified item.
Edit: Click this to edit the start address and end address. See Figure 4-94. The system will check
the IP address validity after the edit operation and implement IPv6 optimization.
Default: Click this to restore the default setup. In this case, the trusted sites and blocked sites are
both null.
Note:
If you enabled trusted sites, only the IPs in the trusted sites list can access the device.
If you enabled blocked sites, the IPs in the blocked sites cannot access the device.
The system supports adding MAC addresses.
Figure 4-93
90
Advertisement
Table of Contents
