Local Basic Operation; Boot Up And Shutdown; Boot Up; Shutdown - Amcrest NVR11H Series User Manual

4 Local Basic Operation

4.1 Boot up and Shutdown

4.1.1 Boot up

Before booting up the NVR, please make sure:

The rated input voltage matches the device's power. Please make sure the power wire connection is
secure. Then press the power on-off button.

Always use stable current. If necessary, an UPS is the best alternative measure.
Please follow the steps listed below to boot up the device.

Connect the device to a monitor and then connect a mouse.

Connect the power cable.

Click the power button at the front or rear panel and then boot up the device. After the device has
booted up, the system is in multiple-channel display mode by default.

4.1.2 Shutdown

Note:
 When you see corresponding dialogue box "System is shutting down..." Do not click the power on-off
button directly.

Do not unplug the power cable or click the power on-off button to shutdown the device directly when
device is running (especially when it is recording.)
There are two ways for you to shutdown the NVR:
a) Main Menu (RECOMMENDED)
From Main Menu->Shutdown, select shutdown from the dropdown list.
Click the OK button and the device shuts down.
b) From the power on-off button on the remote control.
Press the power on-off button on the remote control for more than 3 seconds to shutdown the device.

4.2 Startup Wizard

After the device has successfully booted up for the first time, it goes to the startup wizard.
Click the Next button, and you can see the system goes to the login interface. If the Cancel button is
clicked the startup wizard is skipped. These settings can then be setup manually.
Tips
Check the Startup option, and the system goes to the startup wizard again when it boots up the next time.
Uncheck the Startup option, and the system goes to the login interface directly when it boots up the next
time.
15