Table of Contents
Advertisement
Parameter
Attachment
Receiver
Interval
Health mail
enable
Update period
(interval)
Email test
5.9.2.8 UPnP
This allows you to establish a mapping relationship between the LAN and the public network.
Here you can also add, modify, or remove UPnP item. See Figure 5-36.
In the Windows OS, from Start->Control Panel->Add or remove programs. Click the "Add/Remove
Windows Components" and then select the "Network Services" from the Windows Components
Wizard.
Click the Details button and then check the "Internet Gateway Device Discovery and Control client"
and "UPnP User Interface". Please click OK to begin installation.
Enable UPnP from the Web. If your UPnP is enabled in the Windows OS, the NVR can auto detect it
via the "My Network Places"
Function
The system can send out an email of the snapshot picture
once you check this box.
Input receiver's email address here. Max of three addresses.
It supports SSL and TLS emails.
The send interval ranges from 0 to 3600 seconds. 0 means
there is no interval.
Please note the system will not send out the email immediately
when the alarm occurs. When the alarm, motion detection or
the abnormity event activates the email, the system sends out
the email according to the interval you specified here. This
function is very useful when there are too many emails
activated by the abnormity events, which may result in a heavy
load for the email server.
Please check the box here to enable this function.
This function allows the system to send out a test email to
check if the connection is correct.
Please check this box to enable this function and then set the
corresponding interval.
The system will send out the email regularly according to what
you set here.
The system will automatically send out an email once to test if
the connection is correct. Before the email test is sent, please
save the email setup information.
147
Advertisement
Table of Contents
