Table of Contents
Advertisement
See Figure 4-52.
b)
In Figure 4-52, select trigger snapshot from the dropdown list and then set the picture size,
quality, and snapshot frequency. Click the OK button to save the current setup.
c)
From Main Menu->Setting->Event->Detect you can select the motion detect type, motion detect
channel, and then check the enable box. Please refer to chapter 4.7.3.1.
d)
Click the OK button to complete the motion detect setup.
4.7.4 Alarm Record/Snapshot
4.7.4.1 Alarm Record
a)
Before you set the alarm setup information, please go to chapter 2.3 to connect the alarm input
and alarm output cable (such as light, siren, etc).
b)
The record priority is: Alarm>Motion detect>Regular.
In the Main Menu, from Setting->Event->Alarm, you can see the alarm setup interface. See Figure 4-53.
Alarm in: Here is where you select the channel number.
Event type: There are four types. Local alarm/network alarm/IPC external/IPC offline alarm.
Local input alarm: The alarm signal is detected via the alarm input port.
Network input alarm: This is the alarm signal from the network.
IPC external alarm: This is the on-off alarm signal from the front-end device and can activate
the local NVR.
IPC offline alarm: Once you select this item, the system can generate an alarm when the
front-end IPC disconnects from the local NVR. The alarm can activate recording, PTZ,
snapshot, etc. The alarm can last until the IPC and the NVR connection resumes.
Enable: Please check this box to enable the current function.
Type: normal open or normal close.
Figure 4-52
52
Advertisement
Table of Contents
