Table of Contents
Advertisement
WIFI Working Info: Here you can view current connection status.
Please note:
After a successful connection, you can see a WIFI connection icon at the top right corner of the
preview interface.
When the WIFI verification type is WEP, the system displays as AUTO since the device can not
detect its encryption type.
The system does not support verification type WPA and WPA2. The display may become incorrect
for the verification type and encryption type.
After the device is successfully connected to the WIFI network, you can view the network name, IP
address, subnet mask, default gateway, etc. For supported WIFI models please see Appendix D.
4.11.1.3 PPPoE
The PPPoE interface is shown as in Figure 4-89.
Input the "PPPoE name" and "PPPoE password" you get from your ISP (Internet service provider).
Click the Save button. You need to restart to activate your configuration.
After rebooting, the NVR will connect to internet automatically. The IP in the PPPoE section is the NVR
dynamic value. You can use this IP to access the unit.
Figure 4-88
85
Advertisement
Table of Contents
