Table of Contents
Advertisement
Parameter
Buzzer
Alarm upload
Send Email
Tour
PTZ Activation
Snapshot
5.9.3.2.2 Net Alarm
The network alarm interface is shown as in Figure 5-63.
A network alarm refers to am alarm signal from the network. The system does not support anti-dither nor
sensor type setup for this alarm. For setup information, please refer to chapter 5.9.3.2.1.
5.9.3.2.3 IPC external alarm
The IPC external alarm interface is shown as in Figure 5-64.
The IPC external alarm refers to an alarm signal from an IPC. The system does not support anti-dither
nor sensor type setup for this alarm. For setup information, please refer to chapter 5.9.3.2.1.
Function
local host screen if you enabled this function.
Check this box here to enable this function. The buzzer
beeps when an alarm occurs.
The system can upload the alarm signal to the center
(including the alarm center).
If you enabled this function, the system will send out an
email to alert you when an alarm occurs.
You need to click the setup button to select the tour
channel.
The
system
multiple-window tour according to the channel(s) you set
to record when an alarm occurs. See Figure 5-56.
Here you can set PTZ movement when alarm occurs.
Such as go to preset X. See Figure 5-62.
Click the setup button to select the snapshot channel. See
Figure 5-57.
Figure 5-63
begins
a
1-window
or
163
Advertisement
Table of Contents
