4.4.5 Upgrade
This is to upgrade the network camera.
From Main Menu->Setting->Camera->Remote, the interface is shown as below. See Figure 4-15.
Click the Select button and select the upgrade file. Next select a channel (or you can select the device
type filter to select several devices at the same time.)
Click the Start Upgrade button to upgrade. You can see the corresponding dialogue once the upgrade is
finished.
4.4.6 UPNP
Important
Do not connect a switch to the PoE port, otherwise the connection may fail!
Please connect the IPC to the PoE port on the device's rear panel (Figure 4-16). The system can auto
connect to the network camera. Please note the following figure is for reference only.
Figure 4-14
Figure 4-15
Figure 4-16
26