Table of Contents
Advertisement
Please note the multiple cast function applies to special series only.
4.11.1.11 Alarm Center
This interface is reserved for developers to integrate with our system. See Figure 4-101.
Figure 4-101
4.11.1.12 Register
This function allows the device to auto register with the proxy you specify. In this way, you can use the
client-end to access the NVR etc via the proxy. Here the proxy has a switch function. In the network
service, the device supports the server address of IPv4 or domain.
Please follow the steps listed below to use this function.
Please set the proxy server address, port, and sub-device name at the device-end. Please enable the
auto register function and the device will auto register with the proxy server.
1) The setup interface is shown as in Figure 4-102.
Important
Do not input network default port such as TCP port number.
96
Advertisement
Table of Contents
