Table of Contents
Advertisement
4.4.7 Built-in Switch Setup
The built-in switch function is for products on the PoE port.
From Main Menu->Setting->Network->Switch, you can set the switch IP address, subnet mask, and
gateway. See Figure 4-17.
4.5 Preview
After the device boots up, the system is in multiple-channel display mode. See Figure 4-18. Please note
the displayed window amount may vary. The following figure is for reference only. Please refer to chapter
1.3 Specifications for the window-amount your product supports.
Figure 4-17
Figure 4-18
27
Advertisement
Table of Contents
