Table of Contents
Advertisement
4.10 Alarm
4.10.1 Detect Alarm
In Main Menu->Setting->Detect, you can see the motion detect interface. See Figure 4-69.There are
three detection types: motion detection, video loss, and tampering.
4.10.1.1 Motion Detect
This system can analyze realtime footage and generate a motion detect alarm when motion is detected at
the sensitivity set here.
The detection menu is shown as below. See Figure 4-69.
Event type: From the dropdown list you can select the motion detection type.
Channel: Select a channel from the dropdown list to monitor for motion.
Enable: Check the box here to enable the motion detect function.
Region: Click the Setup button next to Region to view the interface is shown as in Figure 4-69.
Here you can set up to four motion detection zones. Please select a zone first and then left click
and drag the mouse to select a zone. Each zone has is represented by a different color. You can
click the Fn button to switch between the arm mode and disarm mode. In the arm mode, you can
use the direction buttons to control the green rectangle to set the motion detection zone. After
you have finished setting the zones, please click ENTER button to exit the current setup.
Remember to click the save button to save the current setup. If you click the ESC button to exit
the region setup interface, the system will not save your zone setup.
Sensitivity: The system supports 6 levels. The sixth level has the highest sensitivity.
Anti-dither: Here you can set anti-dither time. The value ranges from 5 to 600s. The anti-dither
time refers to how long the alarm signal lasts before it resets and a new alarm can be triggered.
Any alarm within this anti-dither time will be included in the original alarm event and will also
reset the anti-dither countdown. The latch time is not included. The screen prompt, alarm upload,
email and etc will not be activated for alarms within the anti-dither time. For example, if you set
the anti-dither time as 10 seconds, each activation may last 10s if the local alarm is activated.
During this process, if the system detects another local alarm signal at the fifth second, the
buzzer, tour, PTZ
prompt, alarm upload, email will not be activated again. After 10s, if the system detects another
alarm signal, it can generate an alarm since the anti-dither time is out.
Period: Click the Setup button to see the interface is shown as in Figure 4-71. Here you can set
the motion detect period. The system only enables the motion detect operation during the
specified periods. This is not available for video loss or the tampering. There are two ways for
you to set periods. Please note the system only supports 6 periods in one day.
In Figure 4-71, select the
Now the icon is shown as
In Figure 4-71, click
There are four recording types: regular, motion detection (MD), alarm, MD & alarm.
Alarm output: When an alarm occurs, the system enables peripheral alarm devices.
activation, snapshot, record channel will begin another 10s while the screen
icon of several dates and all checked items can be edited together.
. Click
after one date or a holiday to view the interface shown as in Figure 4-72.
Figure 4-68
to delete a recording type from one period.
69
Advertisement
Table of Contents
