Snmp; Multicast - Amcrest NVR11H Series User Manual

4.11.1.9 SNMP

SNMP is an abbreviation of Simple Network Management Protocol. It provides the basic network
management frame of the network management system. SNMP is widely used in many environments. It
is used in many network devices, software, and systems.
You can set in the following interface. See Figure 4-99.
Please enable the SNMP function. Use the corresponding software tool (MIB Builder and MG-SOFT MIB
Browser. You still need two MIB files: BASE-SNMP-MIB, NVR-SNMP-MIB) to connect to the device. You
can get the device's corresponding configuration information after successfully connecting.
Please follow the steps listed below to configure.

In Figure 4-99, check the box to enable the SNMP function. Input the IP address of the PC than is
running the software in the Trap address. You can use default setup for the remaining items.

Compile the above mentioned two MIB file via the software MIB Builder.

Run the MG-SOFT MIB Browser to load the file from the previous step to the software.

Input the device IP you want to manage in the MG-SOFT MIB Browser. Please set the corresponding
version for your future reference.

Open the tree list on the MG-SOFT MIB Browser to get the device configuration. Here you can see
the device information such as how many video channels, audio channels, application version, etc.
Note
A port conflict occurs when SNMP port and Trap port are the same.

4.11.1.10 Multicast

The multicast setup interface is shown as in Figure 4-100.
Figure 4-99
94