Table of Contents
Advertisement
Figure 4-26
The PTZ setup is shown as in See Figure 4-27.
Please note the command name is grey if the device does not support this function.
The PTZ operation is only valid in one-window mode.
Here you can control the PTZ direction, speed, zoom, focus, iris, preset, tour, scan, pattern, aux function,
light and wiper, rotation, etc.
Speed is to control the PTZ movement speed. The value ranges from 1 to 8. 8 is the fastest and 1 is the
slowest. You can use the remote control or click the small keyboard to set.
You can click
and
on the zoom, focus, and iris to zoom in/out, change focus, and adjust
brightness.
The PTZ rotation supports 8 directions. If you are using direction buttons on the remote, there are only
four directions: up/down/left/right.
Figure 4-27
In the middle of the eight direction arrows, there is a 3D intelligent positioning key. See Figure 4-28.
Please make sure your protocol supports this function and you need to use the mouse to control it.
Click this key and the system goes back to the single screen mode. Drag the mouse in the screen to
adjust the section size. The dragged zone supports 4X to 16X speeds. It can use PTZ automatically. The
smaller zone you dragged, the higher the speed.
35
Advertisement
Table of Contents
