Email - Amcrest NVR11H Series User Manual

4.11.1.7 Email

The email interface is shown as below. See Figure 4-95.

SMTP server: Please input your email SMTP server IP here.

Port: Please input the corresponding port value here.

User name: Please input the user name to login to the email.

Password: Please input the corresponding password here.

Sender: Please input sender's email here.
Title: Please input the email's subject here. The system supports English characters and Arabic

numbers. Max 32 characters.

Receiver: Please input receiver email address here. The system supports a max of 3 email receivers.
The system automatically filters the same addresses if you input one receiver repeatedly.

SSL enable: The system supports SSL encryption.

Interval: The send interval ranges from 0 to 3600 seconds. 0 means there is no interval.

Health email enable: Please check the box here to enable this function. This function allows the
system to send out a test email to check if the connection is OK or not.

Interval: Please check the above box to enable this function and then set the corresponding interval.
The system can send out email regularly as you set here. Click the Test button and you can see the
corresponding dialogue box to see if the email connection is OK or not.
Please note the system will not send out the email immediately when the alarm occurs. When the alarm,
motion detection or the abnormity event activates the email, the system sends out the email according to
the interval you specified here. This function is very useful when there are too many emails activated by
the abnormity events, which may result in heavy load for the email server.
Figure 4-94
91