Table of Contents
Advertisement
b)
Select Motion Detect tab. Select a channel from the dropdown list and then check the Enable
button to enable the motion detect function.
c)
Click the Region Select button to set the motion detect zone. There are 396(PAL)/330(NTSC)
small zones. The green zone is the current cursor position. The grey zone is the motion
detection zone. The black zone is the disarmed zone. You can click the Fn button to switch
between the arm mode and disarm mode. In arm mode, you can click the direction buttons to
move the green rectangle to set the motion detection zone. After you have completed the setup,
please click the ENTER button to exit the current setup. Do remember to click the Save button to
save the current setup. If you click the ESC button to exit the region setup interface the system
will not save your zone setup.
d)
Period: Click the Setup button and you can see an interface is shown as in Figure 4-50. Here
you can set the motion detect period. The system only enables the motion detect operation in
the specified periods. This is not for video loss or the tampering. There are two ways for you to
set periods. Please note the system only supports 6 periods in one day.
In Figure 4-50, select the
Now the icon is shown as
In Figure 4-50. Click the
as in Figure 4-51.
e)
Set the sensitivity. Please note the sixth level has the highest sensitivity.
f)
Click the Save button to complete the motion detect setup.
g)
From Main Menu->Setting->Storage->-Schedule. See Figure 4-43
h)
Set the motion detect record channel, period, and the record type should be motion detect (MD).
Please refer to chapter 4.7.2.
i)
Click the Copy button to copy the current setup to other channel(s).
Figure 4-49
icon of several dates and all checked items can be edited together.
. Click
to delete a recording type from one period.
button after one date or a holiday and you can see an interface shown
50
Advertisement
Table of Contents
