Pulse Encoder With Fitting Accessory 6Sg7000 - 2Ac15 - Siemens SIMOTRAS 6SG7050 Operating Instructions Manual

01.04
5.3 Pulse encoder with fitting accessory 6SG7000 – 2AC15
The actual speed value can be measured by this pulse encoder in both directions of rotation. It is
particularly recommended for retrofitting work on the motor shaft (normally on the non-drive end).
The pulse evaluation and 15 V – power supply EW provided directly from the SIMOTRAS HD unit
(see figure for connection). The encoder cable may only be extended using a shielded cable. In
order to simplify fitting to the motor shaft, three connection pins with different threads (M5, M6, M8)
are supplied. The cable length on the pulse encoder is 2 m; ferrules should be fitted to the ends of
the cables.
Encoder type:
Technical data: see user information enclosed with the encoder
WARNING
The connecting pin is mechanically connected to the motor shaft; carelessness may result in
severe personal injury or substantial property damage.
The mechanical and electrical connection of the encoder may only be carried out by qualified
personnel.
Connecting the pulse encoder
Power supply
SIMOTRAS HD
SIEMENS AG 6SG7000-0BA76
SIMOTRAS HD Operating Instructions
IG 06 – ABX – 250 – E1/2,0 – MZ – PP – W04 – 12
P
+15V 26
A
28
B
30
Spare
M
27
29
31
sw
Z
Connecting shields
See Section 6 Figs. 1c or 1d
Pulse encoder
br
ge
ws
gn
gr
Shielded cable
Installation
5-11