Siemens SIMOTRAS 6SG7050 Operating Instructions Manual page 358

Parameter list
PNU Description
11.3 Access authorization levels
P051 Key parameters
*
0 No access authorization
6 Do not set (for use by DriveMonitor)
7 Do not set (for use by DriveMonitor)
9 Do not set (for use by DriveMonitor)
21 Restore factory settings
All parameters are reset to their defaults (factory settings).
Parameter P051 is then automatically reset to factory setting
"40".
22 Do not set
25 Do not set
26 Do not set
27 Do not set
28 Do not set
29 Do not set
40 Access authorization to parameter values for authorized service
personnel
P052 Selection of display parameters
*
0 0 Display only parameters that are not set to original factory
settings
1 Display only parameters for simple applications
3 Display all parameters used
P053 Control word for the permanent memory
*
Disabling or enabling write accesses to the permanent memory
i001: Disabling or enabling write accesses to the parameter memory
0 Only save parameter P053 in the permanent memory;
parameter changes are active immediately but the changed
values are only stored temporarily and are lost when the
electronics supply voltage is switched off
1 Save all parameter values in the permanent memory
i002: Disabling or enabling write accesses to the memory of the
nonvolatile process data
0 Do not save nonvolatile process data in the permanent
memory
1 Save all nonvolatile process data in the permanent memory
If the nonvolatile process data are not stored (P053.002=0),
data are lost when the electronics supply of the SIMOTRAS HD
is switched off, i.e. they have the value 0 after the electronics
supply is switched on again:
K0240: Setpoint of the motor potentiometer
K0309: Motor heating
K0310: Thyristor heating
K9195: Output of the 1st tracking/storage element
K9196: Output of the 2nd tracking/storage element
P054 OP1S – Background lighting
0 ON continuously
1 ON when panel is in use
11-10
Value range
[Unit]
see Column 2
0, 1, 3
0 to 1
[SW 1.7 and later]
1
0, 1
No. indices
Ind: None
FS=40
Type: O2
Ind: None
FS=3
Type: O2
Ind: 2
FS=1
Type: O2
Ind: None
FS=0
Type: O2
SIEMENS AG 6SG7000-0BA76
SIMOTRAS HD Operating Instructions
01.04
See
Change
P052 = 3
P051 ≥ 0
Online
P052 = 3
P051 ≥ 0
Online
P052 = 3
P051 = 0
Online
P052 = 3
P051 ≥ 0
Online