Installation
Cubicle mounting of D400 / 900 Mre converters
• These converters are supplied with 2 fixing angles
SIMOTRAS HD unit by means of the supplied M6 hexagon-head screws (3 per angle) to assist
cubicle mounting.
• The unit can then be supported by 2 further angles
control cubicle.
• The converters must be bolted to the cubicle rear panel in 4 places.
5.1
Dimension drawings
WARNING
A clearance of at least 100 mm must be left above and below the converter in order to ensure
an unrestricted cooling air intake and outlet.
The converter may overheat if this clearance is not provided!
5-2
a
s
a.
These can be bolted to the
s
(not included in scope of supply) in the
SIEMENS AG
6SG7000-0BA76
SIMOTRAS HD
Operating Instructions
01.04