Siemens SIMOTRAS 6SG7050 Operating Instructions Manual page 599

01.04
Microswitch on SIMOTRAS HE (6GA4625
series)
S1 – Override of ramp-function generator in
controlled range
S2 – Speed monitoring
S3 – Brake application time monitoring
S4 – Controlled operation command
S5 – Premature switchover of rotor
contactor stage 1 to "Delay lowering"
mode (counter-torque operation)
S6 – I component of current controller
S7 – I component of speed controller
S8 – Selection of type of setpoint input
SIEMENS AG 6SG7000-0BA76
SIMOTRAS HD Operating Instructions
Corresponding parameter on SIMOTRAS HD
(6SG70 series)
No such setting, as the "zero delay angle" function
is implemented in a different way.
Speed monitoring inactive if P590 = P591
This function must be implemented using free
modules if required (similar to run-back monitoring
on Page K15 in Section 8)
The "zero delay angle" command is inactive when
U605 = 0.
U630 (factory setting = -1.0 %)
P154 (factory setting = 1)
P224 (factory setting = 1)
P700 (factory setting = 0)
Appendix
[G119.2]
[G162.6]
[G113.2]
18-3