Installing Add-On Terminals - Siemens SIMATIC ET 200S Operating Instructions Manual

4.5

Installing add-on terminals

Introduction
● The add-on terminals expand the function of the terminal modules for ET 200S.
● Terminal modules and add-on terminal can be prewired (without COMPACT modules or
● Various voltage groups can be configured on the add-on terminal using pluggable
Requirements
● The mounting rail is installed.
● The terminal module for COMPACT modules is installed or the terminal modules TM-P
Required tools
4-mm screwdriver
ET 200S
Operating Instructions, 08/2008, A5E00515771-06
Extra potentials can be applied to the add-on terminal as necessary
(for example to connect encoders and actuators using 3- and 4- conductor technology
with IM151-1 COMPACT).
The add-on terminal can be cascaded if extra potentials are required.
I/O modules).
bridges.
and TM-E are installed at a width of 120 mm.
Note
Requirements for installing the add-on terminals under terminal modules TM-P and TM-E
Both of the "outside" terminal modules must have the same height. No higher terminal
modules are allowed to mounted between both of these terminal modules.
Installing
4.5 Installing add-on terminals
59