Club Car 2007 Carryall 295 Maintenance And Service Manual page 534

16
HYDRAULIC ATTACHMENT SYSTEM
Figure 16-65 Install Cushioned Piston (If Equipped)
16. Install and tighten nut to 150-185 ft-lb (203-251 N·m) torque (Figure 16-67, Page 16-36).
17. Remove the rod from the vise.
18. Install the cylinder case in the vise.
19. Put oil on the seal surface of the cylinder case (Figure 16-68, Page 16-36).
Figure 16-67 Install and Tighten Piston Nut
20. Put oil on the Teflon seal on the piston (Figure 16-69, Page 16-37).
21. Install the rod assembly in the cylinder case (Figure 16-70, Page 16-37).
22. Put oil on the seals and threads on the head (Figure 16-71, Page 16-37).
23. Use the adjustable gland nut wrench to tighten the head until the head is flush with the case
(Figure 16-72, Page 16-37).
Page 16-36 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Figure 16-66 Install Cushion Sleeve (If Equipped) and
Piston
Figure 16-68 Lubricate Seal
Cylinders