Club Car 2007 Carryall 295 Maintenance And Service Manual page 287

TROUBLESHOOTING AND ELECTRICAL SYSTEM: DIESEL VEHICLES
WAVETEK 5XL
BLUE WIRE
V
V OFF
1000
500
200 200
20
200
WIRE HARNESS
2m
2
200 20
m
m
200
2000
m
k
200k
200
20k
A
2k
! !
V COM 200nA
MAX
1000 ---
FUSED
750V
Figure 11c-47 Voltage At Headlight Socket
TEST PROCEDURE 34 – BED LIFT MOTOR
NOTE: Keep the battery connected during this test procedure.
Ensure that the battery is fully-charged before performing this test procedure.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the red and yellow wires from the bed lift motor (Figure 11c-48, Page 11c-51).
3. Set a multimeter for 20 VDC.
Figure 11c-49 Bed Lift Motor Voltage Reading with
Switch in UP position
4. Place the red probe in the bullet connector on the red wire (wire harness side) and place the black probe
in the bullet connector on the black wire (wire harness side) (Figure 11c-49, Page 11c-51).
5. Have an assistant press the bed lift switch in the UP position and monitor the multimeter:
• A reading of approximately + (positive) 12 VDC indicates that the bed lift harness and switch are wired
correctly. Proceed to step 6.
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
BLACK WIRE
Figure 11c-48 Bed Lift Motor Wires
Figure 11c-50 Bed Lift Motor Voltage Reading with
Switch in DOWN position
11C
Test Procedures
Page 11c-51