Club Car 2007 Carryall 295 Maintenance And Service Manual page 467

DIESEL ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES
Mounting holes in the clutch inner cover have close tolerances. Align the engine and transmission
carefully to ensure the mounting holes in the clutch inner cover match the threaded holes in the
engine and transmission.
5. Tighten the engine bolts and washers to 21 ft-lb (28.5 N·m).
6. Tighten the engine stud bolt nuts to 21 ft-lb (28.5 N·m).
7. Tighten the transmission bolts and washers to 21 ft-lb (28.5 N·m).
8. Install the driven clutch. See Driven Clutch Installation on page 13c-35.
9. Install the drive belt. See Drive Belt Installation on page 13c-29.
10. Install the outer cover. See Clutch Outer Cover Installation on page 13c-35.
11. Connect the battery cables, positive (+) cable first, and tighten the hardware to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
13C
Clutches
Page 13c-37