Club Car 2007 Carryall 295 Maintenance And Service Manual page 38

3
GENERAL INFORMATION
2. Ensure the booster battery is 12-volt. See following NOTE.
NOTE: A starting battery is recommended but a deep cycle battery can be used if necessary.
3. Access the engine compartment by raising the cargo bed. See WARNING "For vehicles with cargo
beds..." in General Warning, Section 1, Page 1-1.
4. Locate the vehicle battery on the driver side of the vehicle under the cargo bed (Figure 3-7, Page 3-6).
5. Connect the end of the first cable (1) to the positive (+) terminal of the booster battery. Connect the other
end of the same cable (2) to the positive terminal of the vehicle battery. See DANGER "Battery – Explo-
sive gases!..." in General Warning, Section 1, Page 1-1.
6. Connect the end of the second cable (3) to the negative (–) terminal of the booster battery. Connect the
other end of the same cable (4) to the battery frame ground.
7. Sit in the driver seat and start the engine.
8. After the engine has started, remove the frame ground (–) cable (4) first. Remove the cable from the pos-
itive terminal (2). Then remove the cables from the booster battery. See following CAUTION.
CAUT ION
• Damage to the alternator can result if the following actions occur:
- Engine is operated with battery cables disconnected.
- Booster cables are connected incorrectly.
2
Figure 3-7 Jump Starting
Page 3-6 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
POS
4
3
1
NEG
Using A Booster Battery (Jump Starting)