Club Car 2007 Carryall 295 Maintenance And Service Manual page 343

ELECTRICAL COMPONENTS: DIESEL VEHICLES
4. Disconnect the 12-gauge blue fusible link from the alternator (Figure 12c-11, Page 12c-15)
(Figure 12c-12, Page 12c-15).
Fusible
Link
Figure 12c-11 18-Gauge Purple Wire and 12-Gauge
Blue Fusible Link at Alternator (60 Amp Shown)
5. Loosen and remove the belt tension adjustment bolt at the top of the alternator (Figure 12c-13,
Page 12c-15).
6. Loosen and remove the alternator mounting bolt at the bottom of the alternator (Figure 12c-14,
Page 12c-15).
7. Remove the belt shield and the alternator from the engine compartment.
8. If necessary, remove the V-belt.
Figure 12c-13 Belt Tension Adjustment Bolt
Alternator and V-belt Installation
1. Place the alternator and belt shield on the engine and insert the alternator mounting bolt through the
shield and alternator and into the engine block (Figure 12c-14, Page 12c-15). Tighten the bolt so that
it is snug but will allow the alternator to pivot when the belt tension is adjusted.
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Nut
Purple
Wire
Figure 12c-12 12-Gauge Blue Fusible Link at Alterna-
tor (40 Amp Shown)
Figure 12c-14 Alternator Mounting Bolt
12C
Alternator
Page 12c-15