Club Car 2007 Carryall 295 Maintenance And Service Manual page 235

TROUBLESHOOTING AND ELECTRICAL SYSTEM: HONDA POWERED GASOLINE VEHICLES
• A reading of approximately – (negative) 12 VDC indicates that the bed lift harness or switch are wired
incorrectly. Check the wiring of the bed lift harness and bed lift switch. See Wiring Diagram on
page 11b-6.
• A reading of approximately 0 VDC indicates a failed bed lift switch, failed bed lift circuit breaker, a poor
connection in the bed lift wire harness, or a broken wire.
6. Place the red probe in the bullet connector on the red wire (wire harness side) and place the black probe
in the bullet connector on the black wire (wire harness side) (Figure 11b-34, Page 11b-38).
7. Have an assistant press the bed lift switch on the instrument panel in the DOWN position and monitor
the multimeter:
• A reading of approximately – (negative) 12 VDC indicates that the bed lift harness and switch are wired
correctly. Proceed to step 8.
• A reading of approximately + (positive) 12 VDC indicates that the bed lift harness or switch are wired
incorrectly. Check the wiring of the bed lift harness and bed lift switch. See Wiring Diagram on
page 11b-6.
• A reading of approximately 0 VDC indicates a failed bed lift switch, failed bed lift circuit breaker, a poor
connection in the bed lift wire harness, or a broken wire.
8. If the bed lift motor does not function and the readings obtained in the previous steps are correct, the bed
lift motor has failed and must be replaced. See Bed Lift Motor Removal, Section 4, Page 4-11.
TEST PROCEDURE 30 – BED LIFT SWITCH
1. Remove the bed lift switch. See Bed Lift Switch Removal, Section 12b, Page 12b-8.
2. Check continuity between the terminals (Figure 11b-35, Page 11b-39) of the switch and compare the
readings with the Bed Lift Switch Continuity Table. If continuity readings do not match the table, replace
the switch. See Bed Lift Switch Installation, Section 12b, Page 12b-8.
Position
Terminal 1
#14 Black w2
Terminal 2
#14 Red w3
Terminal 4
#14 Red w7
Down
Position
REAR VIEW OF SWITCH
Figure 11b-35 Bed Lift Switch Terminals
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Up
Terminal 5
#14 Red w7
Terminal 6
#14 Yellow w5
Terminal 8
#14 Black w2
11B
Test Procedures
Page 11b-39