Club Car 2007 Carryall 295 Maintenance And Service Manual page 273

TROUBLESHOOTING AND ELECTRICAL SYSTEM: DIESEL VEHICLES
BLACK
GRAY
Figure 11c-34 Front Differential Switch
3. Move the accelerator pedal and listen for an audible click from the switch. If there is no click, check the
limit switch for proper alignment and switch arm movement.
4. Place the red (+) probe of the multimeter on one terminal and the black (–) probe on the other terminal
of the switch. With the accelerator pedal fully released, the reading should be no continuity.
5. Apply the accelerator pedal to activate the switch. The multimeter should indicate continuity when the
switch lever is activated. If either reading is incorrect, replace the switch. See Front Differential Limit
Switch Removal on page 12a-13.
TEST PROCEDURE 17 – FRONT DRIVE GEARCASE COIL
See General Warning, Section 1, Page 1-1.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery as instructed. See WARNING "To avoid unintentionally starting..." in General
Warning, Section 1, Page 1-1.
3. Disconnect the two-pin connector between the wire harness and the front drive gearcase located under
the front floorboard.
4. Set the multimeter to 200 ohms.
5. Measure the resistance between the two wires at the two-pin connector (front drive gearcase side).
6. The resistance should be 24.7 to 27.3 ohms.
7. If the resistance is not within the stated range, replace the large output cover sub-assembly. See the
Engines and Drivetrain Components manual (CCI P/N 102396501).
TEST PROCEDURE 18 – ALTERNATOR
See General Warning, Section 1, Page 1-1.
NOTE: Keep the battery connected during this test procedure.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Ensure that the wires are connected correctly and are tight. If they are not, rewire or tighten as necessary.
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
RED
GRAY
11C
Test Procedures
Page 11c-37