Club Car 2007 Carryall 295 Maintenance And Service Manual page 225

TROUBLESHOOTING AND ELECTRICAL SYSTEM: HONDA POWERED GASOLINE VEHICLES
3. Turn the key switch to the START position and release it after the engine starts. If the engine starts and
continues to idle, check the kill wire for grounding. See Test Procedure 16 – Engine Kill Wire on
page 11b-28. See following WARNING.
ý
WARNING
• When the white/black engine kill wire is disconnected, the engine will not stop running
immediately after the key switch is turned to the OFF position. It will be necessary to pull and
hold the choke handle until the engine stops running.
4. Also check the key switch for proper operation. See Test Procedure 18 – Key Switch (Engine Kill Cir-
cuit) on page 11b-29. See preceding WARNING.
5. If the engine does not run, connect the white/black wire at the bullet connector located near the starter
and proceed to Test Procedure 15 – Ignition Spark on page 11b-27.
TEST PROCEDURE 18 – KEY SWITCH (ENGINE KILL CIRCUIT)
See General Warning, Section 1, Page 1-1.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 1, Page 1-1.
3. Raise the hood.
4. Remove the connector from the key switch.
5. Place the red (+) probe on the (M) terminal and the black (–) probe on the (G) terminal. With the key
switch OFF, the reading should indicate continuity. With the key switch turned ON, the reading should
indicate no continuity. If either reading is incorrect, replace the key switch (Figure 11b-24, Page 11b-29).
6. Reconnect the key switch to the wire harness. Ensure that the connector is connected correctly and is
tight. If it is not, repair or replace as necessary.
M
L
WAVETEK 5XL
V V
OFF
1000 500
S
200 200
20
200
2 2m
200
20
m
m
200
2000
m
k
200k
20k 200
2k A
! COM ! 200nA
V
MAX
1000 ---
FUSED
750V
Reading with key switch
in the OFF position
Figure 11b-24 Key Switch Test – Engine Kill Circuit
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
B
G
11B
Test Procedures
Page 11b-29