Club Car 2007 Carryall 295 Maintenance And Service Manual page 208

11B
TROUBLESHOOTING AND ELECTRICAL SYSTEM: HONDA POWERED GASOLINE VEHICLES
TEST PROCEDURE 2 – FUSE
See General Warning, Section 1, Page 1-1.
The fuse block is located on the electrical component mounting plate (Figure 11b-5, Page 11b-12).
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 1, Page 1-1.
3. Remove the electrical component cover.
4. Ensure the wires are connected correctly and are tight. If they are not, rewire or tighten as necessary.
5. Remove the fuse to be tested from the fuse block.
6. Connect the probes of a multimeter set to 200 ohms to the fuse terminals. The reading should be con-
tinuity. If there is no continuity, determine and repair the cause of the fuse failure. Replace the fuse with
a properly rated new one. See following WARNING.
ý
WARNING
• If a fuse is blown, determine the cause of the failure and make necessary repairs before
installing a new fuse. Use the appropriately rated fuse; if a fuse with a higher amp rating is
used, damage to the vehicle electrical system may occur.
Figure 11b-5 Electrical Component Mounting Plate
TEST PROCEDURE 3 – GROUND CABLES
See General Warning, Section 1, Page 1-1.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 1, Page 1-1.
Page 11b-12 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Test Procedures