Club Car 2007 Carryall 295 Maintenance And Service Manual page 234

11B
TROUBLESHOOTING AND ELECTRICAL SYSTEM: HONDA POWERED GASOLINE VEHICLES
Figure 11b-32 Bed Lift Motor Wires
Figure 11b-33 Bed Lift Motor Voltage Reading with
TEST PROCEDURE 29 – BED LIFT MOTOR
NOTE: Keep the battery connected during this test procedure.
Ensure that the battery is fully-charged before performing this test procedure.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the red and yellow wires from the bed lift motor (Figure 11b-32, Page 11b-38).
3. Set a multimeter for 20 VDC.
4. Place the red probe in the bullet connector on the red wire (wire harness side) and place the black probe
in the bullet connector on the black wire (wire harness side) (Figure 11b-33, Page 11b-38).
5. Have an assistant press the bed lift switch on the instrument panel in the UP position and monitor the
multimeter:
• A reading of approximately + (positive) 12 VDC indicates that the bed lift harness and switch are wired
correctly. Proceed to step 6.
Page 11b-38 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Switch in UP position
Figure 11b-34 Bed Lift Motor Voltage Reading with
Switch in DOWN position
Test Procedures