Club Car 2007 Carryall 295 Maintenance And Service Manual page 485

DRIVETRAIN COMPONENTS
Figure 14-24 Forward/Reverse Shifter Cable
at Transmission
Forward/Reverse Shifter Cable Installation
1. Secure a new cable to the transmission end of the nylon cord at the dash frame. Pull and route the cable
from the dash frame to the transmission. See following NOTE.
NOTE: If a nylon cord was not used to remove the cable, carefully feed the cable from behind the dash
frame down between the splash guard and frame, under the vehicle body, and up to the transmis-
sion.
Use care during cable installation and avoid bending the rigid tubular ends of the cable assembly.
2. Secure the cable ball socket to the ball stud on the Forward/Reverse shifter handle at the dash
(Figure 14-22, Page 14-16).
3. Loosen the flanged nut farthest from the handle end as far away from the handle end as the thread will
allow.
4. Advance the front flanged nut away from the rear nut. Allow enough room to install the cable and two
flanged nuts on the Forward/Reverse cable bracket on the dash frame.
5. Adjust the shifter cable. See Forward/Reverse Shifter Cable Adjustment on page 14-17.
Forward/Reverse Shifter Cable Adjustment
1. Verify that the transmission shifter arm is in the NEUTRAL position.
2. Loosen the flanged cable nuts from the cable end at the transmission.
3. Secure the cable ball socket to the ball stud on the transmission shifter arm. See following NOTE.
4. Hold the shifter arm on the transmission in the NEUTRAL position and align the shifter handle with the
neutral position mark on the instrument panel. See following NOTE.
NOTE: This procedure is best performed with the help of an assistant.
5. Advance the front flanged nut, closest to the transmission shifter arm, up against the front side of the For-
ward/Reverse shifter bracket.
6. Advance the rear flanged nut, farthest away from the transmission shifter arm, down next to the back side
of the FNR shifter bracket and tighten the front nut to 25 ft-lb (34 N·m).
7. Move the shifter handle to the FORWARD, NEUTRAL, and REVERSE positions.
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
14
Transmission
Page 14-17