Club Car 2007 Carryall 295 Maintenance And Service Manual page 481

DRIVETRAIN COMPONENTS
7. Remove the driven clutch. See Driven Clutch Removal on page 13b-36 (gasoline vehicles) or Driven
Clutch Removal on page 13c-33 (diesel vehicles).
8. Remove the rear driveshaft. See Rear Driveshaft Removal on page 14-11.
9. Remove the clutch inner cover. See Clutch Inner Cover Removal on page 13b-39 (gasoline vehicles)
or Clutch Inner Cover Removal on page 13c-36 (diesel vehicles).
10. Remove the passenger seat.
11. Honda Powered Gasoline vehicles: Remove the governor guard. See Governor Guard Removal,
Section 13b, Page 13b-19.
11.1. Disconnect the accelerator cable and strain relief grommet from the governor arm (Figure 14-18,
Page 14-13).
11.2. Disconnect the governor cable and strain relief grommet from the governor arm.
11.3. Remove the governor arm.
Figure 14-18 Governor Arm
12. Remove the transmission Forward/Reverse shifter cable ball socket from the ball stud on the transmis-
sion shifter arm (Figure 14-24, Page 14-17).
13. Disconnect the neutral sensing connector from the transmission (Figure 14-19, Page 14-13).
14. Remove the two flange-head bolts, washers, and locknuts from the transmission slotted base brackets
and engine mounting plate. See following NOTE.
NOTE: If the transmission is replaced, remove the base brackets and corresponding hardware. Use new
hardware and the existing base brackets to install the new transmission. Tighten the base bracket
hardware to 39 ft-lb (53 N·m).
If the transmission is not replaced, leave the base brackets attached to help stabilize the transmis-
sion during repair.
15. Lift the transmission body slightly to clear the opening in the engine mounting plate and remove the trans-
mission from the rear of the vehicle sliding the splined shaft out of the front driveshaft.
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Governor Arm
Figure 14-19 Neutral Sensing Connector
14
Transmission
Page 14-13