Club Car 2007 Carryall 295 Maintenance And Service Manual page 408

13B
HONDA GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES
8. Remove the accelerator cable from the plastic retaining clips under the passenger side of the frame. Pull
the cable at the dashboard to remove it from the engine compartment. See following NOTE.
NOTE: Tie a nylon cord to each end of the cable before removing it from the vehicle. Allow the cord to
travel from the attachment points and under the frame. The routed cord can then be used during
installation.
Accelerator Cable Installation
NOTE: When the accelerator cable is replaced, the high-speed RPM must be adjusted. See High-Speed
RPM Adjustment on page 13b-24.
1. Feed the pedal end and governor end of the accelerator cable up into place from under the vehicle on
the passenger side. See following NOTE.
NOTE: Tie the nylon cord routed during removal to the engine end of the cable. Pull the nylon cord to help
feed the cable back through the instrument panel area and engine compartment.
2. Secure the cable to the plastic retaining clips under the passenger side of the frame.
3. Connect the accelerator cable to the pedal.
3.1. Secure the retention clip at the pedal bracket (Figure 13b-13, Page 13b-17).
3.2. Insert the Z-shaped end of cable into the hole in the pedal (Figure 13b-15, Page 13b-18).
3.3. Adjust the accelerator cable retention clip. See Accelerator Cable Retention Clip Adjustment on
page 13b-20.
4. Connect the accelerator cable (5) to the governor arm (4) in the engine compartment (Figure 13b-14,
Page 13b-17).
4.1. Secure the cable strain relief (1) to the transmission governor bracket (2).
4.2. Connect the accelerator cable spring (3) to the governor arm (4).
5. Connect the battery cables, positive (+) cable first, and tighten the hardware to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
Diesel Cable
Figure 13b-15 Z-Shaped Cable End in Hole at Pedal
Page 13b-18 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Gasoline Cable
Engine Control Linkages