Club Car 2007 Carryall 295 Maintenance And Service Manual page 224

11B
TROUBLESHOOTING AND ELECTRICAL SYSTEM: HONDA POWERED GASOLINE VEHICLES
TEST PROCEDURE 16 – ENGINE KILL WIRE
See General Warning, Section 1, Page 1-1.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 1, Page 1-1.
3. Disconnect white/black wire bullet connector located near the starter (Figure 11b-23, Page 11b-28).
4. Connect the red (+) probe of the multimeter to the male bullet terminal on the white/black wire and con-
nect the black (–) probe to the vehicle frame (ground). The multimeter should indicate continuity with the
key switch in the OFF position.
5. With the Forward/Reverse handle in the NEUTRAL position, insert the key and turn the key switch to the
ON position. Note the multimeter reading. Turn the key and hold it in the START position. Note the mul-
timeter reading.
6. There should be no continuity when the key switch is in the ON or START position. If continuity is indi-
cated, check for worn insulation on the white/black wire that grounds the wire to the frame. See Test Pro-
cedure 17 – Grounded Kill Wire on page 11b-28. Also check the key switch for proper operation. See
Test Procedure 18 – Key Switch (Engine Kill Circuit) on page 11b-29.
Figure 11b-23 Engine Kill Wire
TEST PROCEDURE 17 – GROUNDED KILL WIRE
See General Warning, Section 1, Page 1-1.
NOTE: Keep the battery connected during this test procedure.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the engine kill white/black wire (w108) at the bullet connector located near the starter
(Figure 11b-23, Page 11b-28). See following NOTE.
NOTE: Disconnecting the engine kill wire removes the engine ignition circuit from the vehicle start/stop cir-
cuit.
Page 11b-28 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Test Procedures